 |
 |
 |
|
| This is the listing for the machining for 6 Bolt Rods, to fit 2G Pistons on a 7 Bolt Crank. These will start by getting measured and checked for cracks, washing them in our parts washer, followed by bead blasting. After that they will be bored to fit the 2G Piston Wrist Pin, and Blanchard Ground to fit the 7 Bolt Crankshaft. Lastly, we Aline Hone the Crankshaft end, install New ARP Rod Bolts, and balance the rod. This is what we do to all of our Frankenstein Engines, to make sure that this rod conversion is done correctly. These will be bored to press pin diameter, not full floating diameter. Uses 7 Bolt Rod and Crank Bearings. Feel free to contact us with any questions, Thanks!! Cores Required (Four 6 Bolt Rods) |
|
|
|
|
|
|
|
|
